How to make a plywood Tatami Bed

Welcome again! At present i’m going to make a bed in eastern style. These beds are curb than Western beds, with the mattress sunk in a picket frame. I tried to make a design that may without problems be made with multiplex. Even though which you could also use different forms of wooden board fabric incidentally, this design is effortless to take apart and dismantle, very helpful if you wish to transfer. I’ve designed two forms of mattress. That is meant to be used with a a lot-sold steel bed frame you can buy in any retailer. As you will see that, the mattress body rests on these four corners, which again pull all elements collectively. The opposite mattress design is the same measurement. But for this we use a self-made multiplex mattress body. In this video I exhibit you the best way to make the primary variant, even though both beds can be made within the same way with the aid of adjusting the size of some ingredients, we can make this mattress compatible for any measurement Let’s go see how I made it This time, to avoid wasting time, I ordered pre-sawn portions of the same DIY retailer where I bought the gigantic panel, since these materials are rather large. I begin by cutting parts with an angle. They’re used to make the headboard thicker. I also make the rebate across the floor skirting I glue these elements together, later I screw on the mattress rails. Now I glue the highest dree rails together so that they turn out to be improved. I reduce the elements like this and put them in place with glue. I sand these ingredients in advance and screw the mattress rails tightly. Now i will be able to begin assembling the mattress. I cut these two constituents in half of in order that i’ve four supports for the mattress body. First I screw it on the part rails, whilst retaining it 1 mm away from the edge. I take away the section and screw it into the headboard. In this manner the screws will proceed to exert pressure while you screw it back between the connection and the side guide and the headboard will likely be tighter. I’ll use the equal system for the back. I have numbered all angles to make meeting simpler sooner or later. With these final screws I finish the mattress. Now it is time for the bedside tables. I glue these constituents together and add just a little salt to make the glued surface much less tender. As quickly because the glue is dry, I sand the interior part, that’s less complicated now and i proceed to collect the bedside tables. I conclude sanding all materials and paint three layers Water-situated paint. I’ll put the whole lot again together in the workshop to look what the completed mattress appears like. I love what the brink of the plywood looks like. Of direction we will additionally use coloured stain, however i like the natural look of birch wooden.